Filter
Top Products
PELCO Manual C1095M — 4/94 1
INSTALLATION MANUAL
ICIDRD INTERFACE CABLE
FOR INTER-CHECK P.O.S. SYSTEMS
1.0 SCOPE
This manual covers the interface for the ICIDRD
interface cable for the Wayne Dresser Plus 1, Plus 2,
and Plus 3 registers.
The following should be noted prior to installation:
1. This PELCO P.O.S. interface utilizes the
display port of the Wayne Dresser register.
WARNING:
This interface is not a printer
connection. Plugging this interface
into the printer port will damage
the interface.
2.0 INSTALLATION
2.1 LOCATING THE CASH REGISTER
DISPLAY CONNECTION
1. Locate the port labeled DISPLAY at the rear of
the register.
2. If the display port is not labeled, follow the
cable from the customer display back to the
register. The connector you need to locate will
be a 9-pin D-SUB variety.
3. After locating this connector, unplug from the
cash register.
4. Plug PELCO's display interface directly into
the register display port.
5. Plug the register display cable back into the
PELCO interface.
6. Refer to Figure 1 or Figure 2 for the proper
wiring configuration to your Inter-Check unit.
7. Make sure all connections are tight.
8. Check register and display for proper opera-
tion.
2.2 INTER-CHECK UNIT PROGRAMMING
1. Enter the MAIN MENU by pressing [ENTER]
in the monitoring mode.
2. Inter-Check 1000S users press [1] (CHAN-
NEL SETUP).
Inter-Check 2000D users press [1] or [2] de-
pending on the channel you are using for data
display.
3. Press [2] in the CHANNEL MENU (DATA
FORMAT/COMMUNICATION PROTO-
COL).
4. Press [ENTER] or the arrow keys on your
keyboard/keypad until you reach RS232
STANDARD PRINTER.
5. Press [ESC] to save this selection.
6. Program the Communication Setup values
according to Table I. Consult your Inter-Check
manual for pertinent programming informa-
tion.
7. Press [ESC] to return to monitoring mode and
test for proper operation.
®
C1095M