Filter
Top Products
C3408M (12/05)
IPS-MINIADPT
Spectra
®
Mini Adapter Cable
The IPS-MINIADPT adapter cable is required to use the IPS-RMK or IPS-CABLE with the Spectra
®
Mini
dome for on-site setup and testing of the dome and for uploading revised operating software and language
files.
1. Remove the trim ring and dome bubble from the Spectra Mini dome by prying down on the trim
ring at one of the Pelco logos.
2. Plug the six-pin connector on the adapter cable into the mating connector on the dome.
3. Plug the RJ-45 connector on the adapter cable into the mating connector on the IPS-CABLE
(either the IPS-CABLE by itself or the IPS-CABLE that is part of the IPS-RMK remote monitor kit).
4. Follow the instructions in the installation/operation manual that is supplied with the IPS-CABLE
or IPS-RMK.
5. When you are finished, remove the adapter cable and reinstall the trim ring and dome bubble.
TO SPECTRA TO IPS-CABLE
MINI DOME
Figure 1. IPS-MINIADPT Cable
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. ©Copyright 2005, Pelco. All rights reserved.
Endura and ExSite are trademarks of Pelco.
DLP is a registered trademark of Texas Instruments, Inc.