Filter
Top Products
RADIUS
350 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
Accounting Message
This section describes the attributes which will be included by the IOLAN when sending an
accounting message to the RADIUS server.
1 User-Name The name of the user to be authenticated.
4 NAS-IP-Address IP Address of IOLAN LAN interface.
5 NAS-Port Port Line number of IOLAN.
6 Service-Type Indicates the service to use to connect the user to the
IOLAN. A value of 6 indicates administrative access to
the IOLAN. Supported values are:
z 1—Login
z 3—Callback-Login
Equivalent to the IOLAN User Service set by Type
15, Login-Service.
z 2—Framed
z 4—Callback-Framed
Equivalent to the IOLAN User Service set by Type
7, Framed-Protocol.
z 7—NAS prompt
z 9—Callback NAS-prompt
Equivalent to IOLAN User Service DSPrompt.
z 6—Administrative User
z 11—Callback Administrative User
Equivalent to IOLAN User Service DSPrompt and the
User gets Admin privileges.
40 Acct-Status-Type Indicates if this is the beginning or end of a session.
Supported values are: 1 = Start 2 =Stop.
42 Acct-Input-Octets Number of bytes which were received from the user
during this session.
43 Acct-Output-Octets Number of bytes where were transmitted to the user
during this session.
44 Acct-Session-ID A string which identifies the session. The same string
must be used in the start and stop messages.
45 Acct-Authentic Indicates how the user was authenticated. Supported
values are: 1 = Local 2 = RADIUS.
46 Acct-Session-Time Number of seconds for which the user has been
connected to a specific session.
47 Acct-Input-Packets Number of packets which were received from the user
during this session.
48 Acct-Output-Packets Number of packets which were transmitted to the user
during this session.
49 Acct-Terminate-Cause Indicates how the session was terminated: Supported
values include: 1 = User Request 2= Lost Carrier
3=Lost Service 4= Idle Timeout 5= Session Timeout
14 = Port Suspended 16 = Callback.
Type Name Description