Filter
Top Products
TACACS+
354 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
VALUE Perle-Line-Access-Port-4 Disabled 0
VALUE Perle-Line-Access-Port-4 Read-Write 1
VALUE Perle-Line-Access-Port-4 Read-Input 2
VALUE Perle-Line-Access-Port-4 Read-Input-Write 3
VALUE Perle-Line-Access-Port-4 Read-Output 4
VALUE Perle-Line-Access-Port-4 Read-Output-Write 5
VALUE Perle-Line-Access-Port-4 Read-Output-Input 6
VALUE Perle-Line-Access-Port-4 Read-Output-Input-Write 7
...
TACACS+
Although TACACS+ can be used strictly for external authentication, it can also be used to configure
Serial Port and User parameters. Therefore, when a user is being authenticated using TACACS+, it is
possible that the user’s configuration is a compilation of the parameters passed back from the
TACACS+ authentication server, the User’s IOLAN parameters if the user has also been set up as a
local user in the IOLAN, and the Default User’s parameters for any parameters that have not been set
by either TACACS+ or the User’s local configuration.
User and Serial Port parameters can be passed to the IOLAN after authentication for users accessing
the IOLAN from the serial side and users accessing the IOLAN from the Ethernet side connections.
Accessing the IOLAN Through a Serial Port Users
This section describes the attributes which will be accepted by the IOLAN from a TACACS+ server
in response to an authentication request for Direct Users.
Name Value(s) Description
priv-lvl 12-15 (Admin)
8-11 (Normal)
4-7 (Restricted)
0-3 (Menu)
The IOLAN privilege level.
Perle_User_Service 0 (Telnet)
1 (Rlogin)
2 (TCP_Clear)
3 (SLIP)
4 (PPP)
5 (SSH)
6 (SSL_Raw)
Corresponds to the User Service setting in
the IOLAN.
If no value is specified, DSPrompt is the
default User Service.
service = telnet
{
addr =
port =
}
IPv4 or IPv6 address
TCP port number
Settings when Perle_User_Service is set to 0.
service = rlogin
{
addr =
}
IPv4 or IPv6 address
Settings when Perle_User_Service is set to 1.