Filter
Top Products
Server Commands
17 IOLAN DS1/TS2 CLI Reference Guide, Version 4.3
banner
This parameter concerns the banner information (product name/software version). This
banner information is presented to a user with a login prompt. For security reasons, you
can turn off the display of this information. The default is
Off.
break
Enables/disables the existing Reverse Telnet break signal and the out-of-band break
signals for TruePort. The default value is
Off.
bypass-password
When set, authorised users who do not have a password set, with the exception of the
Admin user, WILL NOT be prompted for a password at login with
Local
Authentication
.
dhcp/bootp
Enables the DHCP/BOOTP client process in the IOLAN. By default, this is
disabled/off. If this is enabled, the server IP address parameter is disabled.
mtu
The Maximum Transmission Unit (MTU) size of an IP frame that will be sent over the
network. Only one MTU size can be set for both IPV4 and IPV6 frames
MTU sizes: 68-1500 bytes
Default size: 1500 bytes.
domain_name
Unique name for your domain, your location in the global network. Like Hostname, it is
a symbolic, rather than a numerical, identifier.
flush-on-close
When enabled, deletes any pending outbound data when a port is closed; as opposed to
maintaining the port to send pending data. The default value is
Off.
internet
The IOLAN’s unique IPv4 network IP address. If you are using the IOLAN in an IPv6
network, this field can be left blank.
monitor-connection-every
Specify how often, in seconds, the IOLAN will send a TCP keepalive. This only applies
to line service types that support the keepalive feature. T
Default Interval: 180 seconds.
monitor-connection-timeout
Sets the maximum time to wait for a response after sending a TCP keepalive message.
Values: 1-32767 seconds
Default: 5 seconds
monitor-connection-number
The number of TCP keepalive retries before the connection is closed.
Values: 1-32767
Default: 5
name
You must supply a name for the IOLAN.