Filter
Top Products
331
Management
SFTP Tab Field Descriptions
You must have a SFTP server running on any host that you are uploading or downloading files
to/from.
These are global SFTP settings. They are used whenever the user specifies “SFTP” as the protocol to
be used for the file transfer.
Configure the following parameters:
Note:
Some combinations of cipher groups are not available on FIPS firmware versions.
SSH-1 protocol is not available on FIPS firmware versions.
Enable
Compression
Enables compression of all data. Compression of data is desirable on slow
connections, however on faster networks, compression will degrade overall
data transmission rates.
Default: Disabled
Auto Logon When checked, the IOLAN will automatically log into the SFTP server using
the Name field. If Keyboard Interactive is checked the IOLAN will also send
the configured Password field.
Default: Disabled
Name Enter the user name that will be used to automatically log into the SFTP server.
Password Enter the password that will be used to automatcially log in the SFTP server.
Host Select the host entry from the IOLANs host table which corresponds to the
SFTP server.
HTTP Tunnel Select the HTTP tunnel to be used for this traffic.
SSH 1 enable Enable to negotiation of the SSH1 protocol.
SSH1 Cipher Select the encryption cipher to be used if the SSH1 protocol is used. Valid
options are “3DES” or “Blowfish”.
SSH 2 enable Enable to negotiation of the SSH2 protocol.
SSH2 Cipher Select the encryption cipher(s) to be used if the SSH2 protocol is used. You can
provide up to five values in order of preference. Valid options are “3DES”,
“Blowfish”, “AES”, “CAST” and “Arcfour”.