Filter
Top Products
Setting Jumpers 414
Introduction
2. Open the case by unscrewing the five side screws, two on each side plus the grounding screw,
and lifting off the top of the case. You should see the following configuration for the analog input
board:
3. To configure Channel 1 for Voltage, no jumper should be set (as shown); this is the default
setting. To configure Channel 2 for Current, jumper both J2 pins (as shown).
4. Close the IOLAN case by replacing the case lid and the five screws. You can now power it on
with the new settings.
JP1 JP2
Channel 2
I/O
Channel 1
I/O
Channel 3
Channel 4
JP3
JP4