Philips M1900 Computer Monitor User Manual


 
11
SERIAL
RS-232
VGA
USB
"B"
USB
RETENTION
BRACKET
DVI-D
TOUCH SCREEN
CABLES
VIDEO CABLES
(AUTO ADJ)
MENU
DOWN
SELECT UP
(VGA / DVI)
POWER
Connection of VGA and Touch Screen Cables
Connect either a 15-pin VGA or DVI-D cable and either an RS-232 or USB cable if the monitor is
equipped with a touch screen. All communication cables should include a chassis ground shield.
Hazardous location, Division 2, requires that all cables have adequate strain relief. For this reason,
tighten all connector thumb screws securely. If a USB cable is being used, install the provided USB
retention bracket. Insert the USB connector through the square cutout in the base of the bracket and pull
the cable and body of the connector back through the round hole in the bracket flange. Now insert the
bracket into the two slots on the rear of the monitor and side it forward so the connector is fully inserted in
the mating bulkhead connector. Install and tighten two 4-40 x .25” Philips screws.
NOTE: TO PREVENT INADVERTENT DISCONNECTION OF VIDEO AND/OR
SERIAL TOUCHSCREEN CABLES ASSURE THAT THE THUBSCREWS ARE
SUFFICIENTLY TIGHTENED.
WARNING EXPLOSION HAZARD DO NOT DISCONNECT EQUIPMENT
WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREE
OF IGNITABLE CONCENTRATIONS.
NOTE: WHEN USING USB TOUCHSCREEN CONNECTION THE USE OF THE
USB RETENTION BRACKET IS REQUIRED FOR HAZARDOUS LOCATIONS
AND HIGHLY RECOMMENDED FOR NONHARDAOUS LOCATIONS.
WARNING EXPLOSION HAZARD DO NOT DISCONNECT EQUIPMENT
WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREE
OF IGNITABLE CONCENTRATIONS.