Filter
Top Products
ENGLISH 24
´ST
ORE REFERENCE SETTINGS
This function allows to modify the values of Brightness and Contrast associated to each of the 5 Reference Settings of the unit. The change is oper-
ated on the currently active Ref. Setting in OSD Global Menu.
The sequence of operations is:
➢ Select the reference to be changed in OSD Global Menu (1 to 5).
➢ Set the desired values using keys
AA
Brightness -/+ and
BB
Contrast -/+. LED will turn to RED because setting is out of ref.
values.
➢ When Brightness and Contrast values are set as required, enter OSD and select the Local Menu ‘STORE REF. SETTING’ item.
The LED will turn GREEN, to show that the setting is now stored.
Pressing the “SELECT” key, the current Brightness and Contrast values are stored in the active Reference Setting Memory.
The Local Menu disappears and a new window will be displayed indicating information about which one of the Reference Settings has been
updated.
´HORIZONTAL SIZE / VERTICAL SIZE / HORIZONTAL SHIFT / VERTICAL SHIFT / TILT
When the Local Menu window is displayed, if one of the following item is highlighted: “H.SIZE”, “V.SIZE”, “H.SHIFT”, “V.SHIFT”, “TILT”
A first “SELECT” key press makes the line blinking; the corresponding parameter can now be modified using + and - keys.
A further “SELECT” key press makes the line stop blinking. This way the value is also saved in memory.
If you press the “EXIT” key when the message is blinking the new parameter value remains active but is not saved in memory.
Pressing the “EXIT” key, the Local Menu disappears.
When displaying a new timing not yet known by the monitor, you can adjust all the geometry parameters and then automatically store them in mem-
ory. The associated CHANNEL NUM will be shown in the SHOW-CONFIG window of the Local Menu.
Note:
When the ORBITING function is enabled, all the geometry adjustments from the OSD Local Menu are inhibited. If an attempt is made to modify one
of following items: H. SIZE, V.SIZE, H. SHIFT, V. SHIFT and TILT, on the corrisponding menu line the blinking warning message ‘ORBITING ON
’
is
displayed.
To modify one of the geometry parameters the Orbiting Function must be disabled first.
LOCAL MENU
SEL EXIT - +
OSD REVERSE
SHOW CONFIG.
STORE REF. SET.
STORED
REF. SETTING 3
LOCAL MENU
SEL EXIT - +
OSD REVERSE
SHOW CONFIG.
H. SIZE 75
LOCAL MENU
SEL EXIT - +
SHOW CONFIG.
H. SIZE 75
V. SIZE 66
LOCAL MENU
SEL EXIT - +
H. SIZE 75
V. SIZE 66
H. SHIFT 88
LOCAL MENU
SEL EXIT - +
V. SIZE 66
H. SHIFT 88
V. SHIFT 43
LOCAL MENU
SEL EXIT - +
H. SHIFT 88
V. SHIFT 43
TILT 57