Filter
Top Products
Philips Semiconductors
User’s Manual - Preliminary -
P89LPC906/907/908
TIMERS 0 AND 1
2003 Dec 8 42
Figure 5-2: Timer/Counter Auxiliary Mode Control register (TAMOD)
MODE 0
Putting either Timer into Mode 0 makes it look like an 8048 Timer, which is an 8-bit Counter with a divide-by-32 prescaler. Figure
5-4 shows Mode 0 operation.
In this mode, the Timer register is configured as a 13-bit register. As the count rolls over from all 1s to all 0s, it sets the Timer
interrupt flag TFn. The count input is enabled to the Timer when TRn = 1. TRn is a control bit in the Special Function Register
TCON (Figure 5-3).
The 13-bit register consists of all 8 bits of THn and the lower 5 bits of TLn. The upper 3 bits of TLn are indeterminate and should
be ignored. Setting the run flag (TRn) does not clear the registers.
Mode 0 operation is the same for Timer 0 and Timer 1. See Figure 5-4.
Mode 1 is the same as Mode 0, except that all 16 bits of the timer register (THn and TLn) are used. See Figure 5-5.
MODE 2
Mode 2 configures the Timer register as an 8-bit Counter (TLn) with automatic reload, as shown in Figure 5-6. Overflow from TLn
not only sets TFn, but also reloads TLn with the contents of THn, which must be preset by software. The reload leaves THn
unchanged. Mode 2 operation is the same for Timer 0 and Timer 1.
TAMOD - P89LPC907
Address: 8Fh
Not bit addressable
Reset Source(s): Any reset
Reset Value: xxx0xxx0B
BIT SYMBOL FUNCTION
TAMOD.7-1 - Reserved for future use. Should not be set to 1 by user programs.
TAMOD.0 T0M2 Mode Select bit 2 for Timer 0. Used with T0M1 and T0M0 in the TMOD register to
determine Timer 0 mode (P89LPC907).
TnM2-TnM0
Timer Mode
0 0 0 8048 Timer “TLn” serves as 5-bit prescaler. (Mode 0)
0 0 1 16-bit Timer/Counter “THn” and “TLn” are cascaded; there is no prescaler. (Mode 1)
0 1 0 8-bit auto-reload Timer/Counter. THn holds a value which is loaded into TLn when it
overflows. (Mode 2)
0 1 1 Timer 0 is a dual 8-bit Timer/Counter in this mode. TL0 is an 8-bit Timer/Counter controlled
by the standard Timer 0 control bits. TH0 is an 8-bit timer only, controlled by the Timer 1
control bits (see text). Timer 1 in this mode is stopped. (Mode 3)
1 0 0 Reserved. User must not configure to this mode.
1 0 1 Reserved. User must not configure to this mode.
1 1 0 PWM mode (see section "Mode 6 - P89LPC907").
1 1 1 Reserved. User must not configure to this mode.
76543210
-------T0M2