Filter
Top Products
1. Locate an optimum location and use the provided Mounting kit to tie the
WAP-6200 to a pole.
Note:
For secured reason, while install the CPE AP, please be
aware for the electric wires around, and tighten the pole.
Without tighten the CPE AP, the pole and the installed site is
with electric wire around, there could be danger of being hurt
by falling or lethal injury.
2. Connect the RJ45 connector of the WAP-6200 to a standard UTP cable.
3. Be noted, there are 2 ways for RJ45 cable connector that can be considered to
avoid water.
a. Stick and bind with adhesive tape on RJ45 cable connector after connect the
cable to “P+DATA OUT” port of PoE Injector.
b. After connecting cable to “P+DATA OUT” port of PoE Injector, open the Back
Cover and put the RJ45 cable connector inside the Back Cover, then plug the
Back Cover to CPE Set and seal the hole where the UTP cable comes out.
4. Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE
Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the PC
on the same LAN for management.
5. Connect the power cord to the PoE Injector, and plug it into an AC outlet to power
on the WAP-6200.
Note:
Strongly suggest using SFTP cable, for better protection of
the data wire. 25-meter SFTP cable also available by order,
the part no is WL-SFTP-25. Please contact with local dealer
for more information
Note:
To avoid thunder strike, consider to install ELA-100, thunder arrester
toward the CPE AP and the PoE injector.