Filter
Top Products
Plasmon
V
15 AIT Tape Library User Manual
Page 86
Connecting to the Console Interfaced
This section describes how to connect your library to the host computer and access the console interface.
You can use console for upgrading firmware, creating a diagnostic listing, and viewing the LCD password.
Before accessing the console interface, you must have the following:
•
Host computer that uses an RS232 serial port.
•
A straight-through 9-pin serial cable (not a null modem cable) with a male “D” connector.
•
Terminal emulation software, such as HyperTerminal, that supports the ANSI 3.64 terminal
protocol.
NOTE
Plasmon recommends that you use HyperTerminal, a standard
communications package available with Windows.
Connecting the Serial Cable
Connect the 9-pin cable to the back of the library and to the host computer. The following figure shows the
location of the 9-pin serial port on the back of the library.
Figure 29. Serial Port Connector
9-pin serial port