Filter
Top Products
System Management
15–29
3 Select the file in question, and then click Open.
The file to select has the extension .bin.
4 In the Start RFP No field, type the number of the first base station to be
updated.
Note: You can check base station numbers under Administration/Base
station.
5 In the End RFP No field, type the number of the last base station to be
updated.
6 Click Update.
Wait until the system has finished updoading. All base stations in the
range specified are updated.
Note: You can check the update status under Administration/Base
station while the update is progressing. Each update takes approximately
30 seconds.
7 Optionally, you can block new calls during a firmware update by clicking
Administration, and then Wireless Server.
Figure 15-44Adm. Page WS: Administration/WS page
Under Service Status click Block.
8 When the update is finished, click Reboot to execute the changes.
9 If you have blocked new calls during a firmware update, enable new calls
again by clicking Administration, then Wireless Server and then clicking
Allow.