Filter
Top Products
KIRK Wireless Server 6000 Installation and Configuration Guide
8–12
Retrieving the Serial Number of the KIRK Handset
To enable service to the handset, the serial number must be programmed into
the system database via the web based Administration Page of the KWS6000.
(For more information, refer to “Registering KIRK Handsets” on page 13-1).
The serial number (IPEI number) of each handset is found either on a label,
which is placed behind the battery, or on the packaging label.
To show the serial number on the handset display (3040 Handset/4020
Handset/4040 and 4080 Handset), press *99984*, and then press
3; the serial
number appears on the handset display. Press < for 5 seconds to exit the menu.
To show the serial number on the handset display (5020/5040 Handset), press
Menu, select Status and then select Firmware version. Press exit to exit the
menu.
Retrieving Serial Number on KIRK 3040 Handsets
This section describes how to retrieve the serial number on a 3040 Handset.
1 Press down the back cover and push it 5 mm towards the headset plug.
Figure 8-10 Remove Back Cover from Handset
2 Lift off back cover.
3 Lift the battery and read the serial number.
4 Replace battery and back cover.
Note
To show the serial number on the handset display, press *99984*, and then
press
3; the serial number appears on the handset display. Press < for 5
seconds to exit the menu.