Filter
Top Products
ViewStation EX User Guide
244 www.polycom.com
3. Follow the on-screen instructions to download the application.
When you launch the PolycomSnap application, the following
interface is displayed:
Figure 7-9. PolycomSnap Interface
4. Click the Connect tab of the PolycomSnap interface. Enter the IP
address of the system in the Address field. This is the IP address
of the system to which the snapshots are to be sent.
A password may be required. The password is the Meeting
Password which is set in the Security screen (System Info >
Admin Setup > Security) of the system, or in the User Setup
screen (System Info > User Setup).
5. Click the Connect button. Your system is now ready to receive
snapshots.
6. Click the Area tab. Select the snapshot area you want to capture.
7. Click the Snapshot tab. Select the snapshot capture mode.
8. Then press the PolycomSnap Snap button, or press F9 on your
PC keyboard to send a snapshot of your PC desktop to the
system connected to your system.
9. To disconnect, click the Disconnect button under the Connect
tab.