Filter
Top Products
7
Introduction
This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and
maintenance procedures for a Powermatic Model 2700 Shaper. This manual contains instructions on
installation, safety precautions, general operating procedures, maintenance instructions and parts
breakdown. This machine has been designed and constructed to provide years of trouble free operation if
used in accordance with instructions set forth in this manual. If there are any questions or comments,
please contact either your local supplier or Walter Meier. Walter Meier can also be reached at our web
site: www.waltermeier.com.
Specifications
Model Number .............................................................................................................................. 2700
Motor Stock Number
3HP, 230V, 60Hz, 1 Phase .................................................................................................. 1280100C
5HP, 230V, 60Hz, 1 Phase .................................................................................................. 1280101C
5HP, 230V/460V-prewired 230V (for 460V see Note below), 60Hz, 3 Phase........................... 1280102C
Table Size (L x W) .................................................................................................................. 40" x 30"
Spindle Size (Standard) .............................................................................. 3/4", 1-1/4" Interchangeable
Router Bit Collet Size (Optional) .............................................................................................. 1/4", 1/2"
Spindle Capacity Under Nut:
3/4” Spindle (provided)........................................................................................................ 3-3/4"
1-1/4” Spindle (provided)...........................................................................................................6”
1” Spindle (optional accessory)............................................................................................ 5-3/4”
1/2” Spindle (optional accessory) ......................................................................................... 3-1/8”
30mm Spindle (optional accessory) ..................................................................................... 3-1/2”
Spindle Travel ...................................................................................................................................4"
Spindle Speeds (RPM) ....................................................................................... 7500, 10000, reversing
Table Opening Diameter ............................................................................................................... 7.33"
Insert Opening Diameters........................................................................................... 2.55", 4.16", 5.75"
Fence Size x 2................................................................................................... 4-7/8" (H) x 18-3/4" (W)
Dust Collection Minimum CFM Required 4" Port ............................................................................... 600
Overall Dimensions ........................................................................................ 40" (L) x 37" (W) x 45" (H)
Weight ................................................................................................. 690 lbs (Shipping), 664 lbs (Net)
Note: For 460V operation, magnetic switch (Part No. PM2700-114C) must be purchased separately and
installed. A qualified electrician is recommended.
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier reserves the right to change specifications at any time and without
prior notice, without incurring obligations.
Read and understand the entire contents of this manual before attempting
assembly or operation! Failure to comply may cause serious injury