Filter
Top Products
SPECIFYING FORMS
54
Automatic Scroll Delay
Auto-Scroll
1 Second Delay
Possible Values: Off, 1* to 15 Second Delay
This item sets the number of seconds to delay before scrolling the top of
form to the tear bar when the printer is idle (no additional data received
since the last print operation) and a form boundary (bottom of the form
according to the Form Length setting for the current form) has been
reached. If printing finishes and the form boundary has not been reached,
take the printer off line and the LOAD/FEED button may be used to advance
the form to the tear bar. This item may also be used to disable Auto-Scroll
by setting the value to Off. When disabled, the LOAD/FEED button must
always be used to advance the form to the tear bar.
Tear-Off Distance
Tear-Off
0.00 Inches
Possible Values: 0.00* … 9.99 Inches
This item sets the additional distance the paper will advance when scrolling
to the tear bar. This allows the printer to be placed under a slot in a counter
and have the tear-off positioned at the counter surface. Leave the distance
set to 0.00 Inches to disable this feature. To set the value, use the
UP/DOWN ARROW buttons to change the value. Holding the buttons will
cause the value to change rapidly. The paper will move accordingly to
allow verification of the setting. Note that the setup Menus will not
terminate when closing the lid while in this mode.
Paper Out Fault Action
Paper Out
Fault
Finish Page
Possible Values: Finish Page*
Reprint Page
Break Page