Filter
Top Products
SPECIFYING FORMS
60
When this item is set to Barber Pole, the printer will print a rotating
character pattern. Printing may be started and stopped with the ONLINE
button.
When set to Hex Dump, the printer will print all received data in a special
debug format, which may be used by programmers to solve software
problems. For more information, refer to the Hex Dump section of the
PrintMaster 850 Series Programmer’s Manual.
Note the when in Barber Pole mode and Hex Dump mode, if the printer is
taken OFFLINE during printing, the printer will remain in these modes. If the
printer is put back ONLINE, printing will resume. To exit either of these
modes, return to the TEST MENU and use the UP/DOWN arrow keys to
set “TEST MODE” to OFF.
FORM CONSTRUCTION AND LAYOUT
TIPS
Form Construction
Although the PrintMaster 850 Series printers have been designed to handle
difficult forms, you may come across a form that does not feed reliably or
provide adequate print quality on all copies.
One of the main causes of paper misfeeds is a form that is “tented”. Tenting
is a tent-like bulge at the perforation when forms are unfolded from the box.
The printer allows a maximum form thickness of 0.025 inches, which a
badly tented form may exceed.