Filter
Top Products
Printek Emulation
100
Vertical Tabs
Vertical tab stops are associated with absolute physical positions, not with lines. The tab stops are set
relative to the current line spacing, but subsequent changes in line spacing will not affect the physical position
of the tab stops.
Vertical Tab VT
Causes the current line to be printed, and then advances the paper to the next vertical tab stop. If no vertical
tab stops are set, then a line feed is done instead. If “Auto CR” is set to “On” in the interface setup menu, a
carriage return will also be performed.
Control code: VT
Hexadecimal: 0B
Set Vertical Tab Stops ESC VT n1 n2 ... nx NUL
Clears all currently set vertical tab stops, and sets new tab stops at line n1, n2, n3, etc. 1≥n≥255. The tab
stops must be presented in ascending order. The NUL character, or any tab stop value less than the
preceding one, terminates the sequence. The tab stop settings are based on the current line spacing.
Changing the line spacing after the tab stops are set will not affect the position of the tab stops. The first line
is line zero.
ESC VT NUL or ESC R will clear all currently set vertical tab stops, leaving no vertical tab stops set.
Example: The following escape sequence will set vertical tab stops at line 6, 12, and 24. If line spacing is
currently 6 lpi, this will result in tab stops one inch, two inches, and four inches from the top of the form.
Escape Sequence: ESC VT 6 12 24 NUL
Hexadecimal: 1B 0B 06 0C 18 00
Horizontal and Vertical Tabs
Reset Horizontal and Vertical Tab Stops ESC R
Clears all currently set horizontal tab stops, and restores the default horizontal tab stops. Default horizontal
tab stops are set at every eighth column, i.e. column 8, 16, 24, 32, 40, etc. Clears all currently set vertical
tab stops.
Escape Sequence: ESC R
Hexadecimal: 1B 52