Filter
Top Products
Genicom 3840 and 3410 ANSI Emulation
113
Escape Sequence: ESC K
Hexadecimal: 1B 4B
Superscript Printing PLU
Moves paper ½ line above the current line for superscript printing.
If 8-bit control code processing is enabled then.
Control Code: PLU
Hexadecimal: 8C
Superscript Printing ESC L
Moves paper ½ line above the current line for superscript printing. ESC L is also used to return to the
original line following ESC K (subrscript).
If 8-bit control code processing is enabled then.
Escape Sequence: ESC L
Hexadecimal: 1B 4C
NOTE: The partial line up does not respect top of form; that is, following a form feed, ESC L causes a
partial line movement upward. Also, partial line down does not respect bottom of form; that is, when printing
the last line on the form, ESC L causes a partial line movement downward.
CAUTION: When printing the last line on a form, do not send a line feed (LF) code to move directly from
superscript to subscript. The LF code will be acted upon as the bottom of form terminator.
Horizintal Position
Carriage Return CR
Initiates printing and returns the current print position to the left margin.
Control Code: CR
Hexadecimal: 0D
Backspace BS
Prints the data in the print buffer, then moves the print position one character position to the left.
Control Code: BS
Hexadecimal: 08
Set Auto CR ON LF ESC [(p)h
P effect
20 auto CR on LF