Filter
Top Products
60
Dedicated Searches
61
Dedicated Searches
Dedicated Signal Stalker II
Dedicated STLK mode lets you access and run Signal Stalker II easily
and quickly.
In Manual, Program or Scan mode, press FUNC SCAN to access the
Signal Stalker II dedicated mode.
Note: When a signal is being received, the Band softkey (F1)
changes to FrL/O. You can access the Band softkey by pressing
FUNC F1 when the F1 key function is FrL/O.
Operation of the dedicated Signal Stalker II mode is almost identical
to that of the object mode, with one exception. When dedicated
Signal Stalker II mode is used, you may press the numeric key on
the keypad that corresponds with the sub-band you wish to enable
or disable. Disabling a sub-band will cause the Signal Stalker II
system to skip the frequencies within that sub-band as it performs its
sweeps.
Signal Stalker II sub-bands:
Freq. (MHz) Band
0 25-54 MHz VHF Low Band
1 108-137 VHF Aircraft Band
2 137-174 MHz VHF High Band
3 216-300 220 MHz Commercial/
Amateur Band
4 300-406 UHF Military Air Band
5 406-470 UHF Band
6 470-512 UHF-T Band
7 764-806 700 MHz Band
8 806-869 800 MHz Band
9 896-1300 MHz 900 MHz Band, 23 cm
Amateur Band
Public Safety sub bands:
Freq. (MHz) Band
0 33.4-46.5 VHF Low Band
1 151-170 VHF High Band
2 453-467 UHF Band
3 764-806 700 MHz Band
4 851-869 800 MHz Band
Dedicated TUNE Search
Your scanner’s dedicated TUNE mode provides you with the ability
to quickly enter any frequency and monitor that frequency for
transmissions, or search up or down from that frequency for activity.
1. To enter
TUNE
mode, press TUNE. The scanner displays the
TUNE
screen.