Radio Shack 20-197 Scanner User Manual


 
70
Scanner Memory
71
Scanner Memory
Using V-Scanners
You can save active scanner configurations (called “working” or
“main” memory) to a V-Scanner storage folder for later use. Then
recall the stored scanner configurations from a V-Scanner storage
folder to main memory when you want to use them.
When you recall a configuration from a V-Scanner storage folder
and use it in main memory, any changes you make while using
the configuration will not automatically be transferred to the
configuration data stored in the V-Scanner storage folder. You
must save your changes back to that folder location if you want to
preserve them for later use.
When you load a new configuration into main memory, the
contents of main memory are overwritten and lost, unless you save
your main memory to a V-Scanner storage folder first. Once the
configuration data in main memory has been overwritten, it cannot
be recovered—there is no “Undo” function.
Saving Main Memory to a V-Scanner Folder
1. Press FUNC, then PROG to enter V-Scanner mode.
2. Press the Stor softkey.
3. Press p or q to scroll to the desired V-Scanner folder, then
press the Stor softkey.
4. If the selected V-Scanner folder already contains data, you will
be asked if you wish to overwrite the existing data with new
data from your current version of main memory. Press the YES
softkey to proceed, or the NO softkey to cancel.
5. The scanner will prompt you to enter a name for the stored V-
Scanner. Use the standard text entry method to type the name
you wish to use, then press the OK softkey.
6. The scanner will write the contents of main memory to the
V-Scanner folder. This will take approximately four seconds to
complete.
Loading a V-Scanner Folder to Main Memory
1. Press FUNC, then PROG to enter V-Scanner mode.
2. Press the Load softkey.
3. Press p or q to scroll to the desired V-Scanner folder, then press
the Load softkey.
4. The scanner will ask you to confirm that you wish to overwrite
the current contents of main memory. Press the YES softkey to
proceed, or the NO softkey to abort.
The data transfer takes approximately 4 seconds
to complete.
Erasing V-Scanner Folders
1. Press FUNC, then PROG to enter V-Scanner mode.
2. Press the Eras softkey.
3. Press p or q to scroll to the desired V-Scanner folder, then press
the Eras softkey.
4. Press the YES softkey to delete current contents, or press the NO
softkey to abort.
Cloning
You can transfer the programmed data to and from another PRO-197
(or PRO-106) scanner using a connecting cable which has
1
/
8
-inch
stereo phone plugs on both ends (not supplied).
To clone the scanner data:
1. Turn on both scanners.
2. Connect the connecting cable to each scanner’s
PC/IF jack.
3. Press PROG, then the GLOB softkey to enter the Global Settings
menu.