Filter
Top Products
92
Additional Information
93
Additional Information
Initializing the Scanner to Factory Defaults
If initializing the global parameters to factory defaults does not
resolve your problem, you may wish to initialize the entire scanner
to factory defaults. This operation will result in the clearing of your
programmed data and the loss of any custom changes you have
made to the radio’s global parameters. Use this option as a last
resort, and, if possible, save your working memory to a V-Scanner
folder prior to performing this operation.
Note: This procedure clears all information you stored in the
scanner’s working memory, AND resets the global parameters to
factory defaults. Initialize the scanner only when you are sure the
scanner is not working properly. V-Scanner memory is not affected
when the scanner is initialized.
1. Turn off the scanner, then turn it on again.
The scanner briefly displays the DSP boot version, and then the
Welcome/Owner screen is displayed.
2. Press 0 while the scanner is displaying the Welcome/Owner
screen. The scanner displays:
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 1. The scanner displays:
Factory Init
Erase Memory
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays:
Initializing the
File System
Please Wait.....
File System
Initialized to
Defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner displays:
GLOB EEPROM area
Initialized to
defaults.
Press any key.
6. Press any key on the keypad to proceed. The scanner will reboot
with file system and global parameters reset to factory defaults.