Filter
Top Products
36
37
Troubleshooting
Problem Cause Solution
Scanner is on
but will not
scan.
Squelch is not
adjusted correctly.
Adjust squelch.
Only one channel
or no channels are
stored.
Store frequencies
into more than one
channel.
Scanner does
not turn on.
Batteries are
discharged.
Recharge the
rechargeable
batteries or replace
the non-rechargeable
batteries.
The AC adapter is
not connected
Be sure the adapter’s
barrel plug is fully
plugged into the
jack.
Scanner
keypad
doesn’t work.
The keylock
function is
activated.
To turn off the
keylock, press Func
+ KEYLOCK. Keypad
unlocked appears.
&
is
flashing.
Batteries are low. Recharge the
rechargeable
batteries or replace
the alkaline batteries.
Poor or no
reception.
Batteries are weak
or completely
discharged.
Check the batteries
or make sure the AC
adapter is connected
properly.
Antenna is loose. Make sure an
antenna is connected
to the scanner.
Invalid Freq.
appears.
Programming
error.
Re-enter the
frequency or number
correctly, including
the decimal point.
Scanner
display locks
up or stops
operating
properly
Internal error. Turn scanner off
and on again, or
disconnect and
reconnect power
source.
Internal error. Reset the scanner.
Resetting the Scanner
Caution: This procedure clears all the information
you have stored in the scanner. Before you reset
the scanner, try turning it off and on to see if it
begins working properly. Reset the scanner only
when you are sure it is not working properly.
1. Turn off the scanner. If you cannot turn off the
scanner, remove the battery and install again.
2. While holding down 2, 9 and SCAN, turn on
the scanner. Initializing…Please wait appears as
the scanner clears its memory.
Note: Do not turn off the scanner again until
Initializing…Please wait disappears. Otherwise,
the scanner might not clear its memory properly.
Additional Information
FCC Notice
Your scanner might cause radio or TV interference
even when it is operating properly. To determine
whether your scanner is causing the interference,
turn off your scanner. If the interference goes
away, your scanner is causing it. Try the following
methods to eliminate the interference:
• Move your scanner away from the receiver.
• Connect your scanner to an outlet that is on a
different electrical circuit from the receiver.
• Contact your local RadioShack store for help.
In some areas, mobile use of a scanner is
unlawful or requires a permit. Check the laws
in your area.
This device complies with Part 15 of the FCC
Rules. Operation is subject ot the following two
conditions: (1) This device may not cause harmful
interference. (2) This device must accept any
interference received, including interference that
may cause undesired operation.