Filter
Top Products
PRO-27 20-Channel Programmable Scanner
(200-0507) Searching For Active Frequencies
SEARCHING FOR AND STORING ACTIVE FREQUENCIES
You can set your scanner to search for transmissions:
Within any one of the seven pre-programmed frequency bands
(BAND SEARCH).
You can select these bands using the number keys 1-7.
1: 29 - 54 MHz 5:406 - 450 MHz
2:l37 - 144 MHz 6:450 - 470 MHz
3:144 - 148 MHz 7:470 - 512 MHz
4:148 - 174 MHz
Starting from a band where you have stored a frequency
(DIRECT SEARCH).
Follow these steps to search for active frequencies.
1. While the scanner is stopped, enter the channel number where you want
to either:
Store a frequency the scanner finds while searching any of the seven
preprogrammed bands.
Replace a stored frequency with another frequency the scanner finds
while searching the same band as the stored frequency.
NOTE: When you enter a two-digit channel number (10-19), the display
shows only one digit at a time. After you press MANUAL, the
display shows the full two-digit number. When you enter CH 20,
the display shows "0".
2. Press MANUAL then B-SRCH. Then, while K/L, L/O, and WX flash on the
display, do either of these things:
Start BAND SEARCH by entering the number of the frequency band you
want to search. The scanner searches starting from the selected
band's lowest frequency.
Start DIRECT SEARCH by pressing 8/DOWN ARROW to search downward or
9 UP ARROW to search upward. The scanner searches the band that
contains the channel you selected.
NOTES: If you do not start band search or direct search while K/L,
L/O, and WX flash on the display, the scanner automatically
searches the previously searched band.
When the scanner searches upward, the display segments cycle
clockwise. When the scanner searches downward, the display
segments cycle counterclockwise. While searching, the
selected band number (BAND SEARCH) or d (DIRECT SEARCH)
briefly appears at each cycle.
To change the frequency band, simply select the desired band
1