Filter
Top Products
6. ROUTINE OPERATION
6-1
Basic Transmission
Before transmission, refer to page 31 to program your line type (i.e. Pulse
or Tone) and page 32
– Preparation –
1. Make sure that the
status (the machine
or AUTO mode).
to program your transmission terminal identification.
machine is in stand-by -
can be in FAX, TEL
~
2.
3.
4.
Carefully place the document(s) into the feeder face down along the
guide.
● Do not insert more than 10 pages at once.
● Loosen any pages stuck together.
● Align the leading edges.
● Adjust the guide to the document width.
● Transmit sheets of different width separately.
NOTE:
1. Refer to page 12 and 13 to make sure that your document is suitable for use.
2. Documents may also be fed in manually, one at a time.
During transmission, the next sheet must be placed in the feeder.
You can select “DETAIL”, “HALITONE”, and
“DARKEN” modes for transmission if necessary.
Press the “DETAIL”,
“HALITONE”, and “DARKEN” keys to have
the “DETAIL”, “HALFI’ONE”, and “DARKEN” indicators turn on.
Detail: Documents with small print or fine details.
Halftone: Documents containing photographs; transmission will be
slower.
Use the “Detail” setting with Halftone for best reproduction.
Darken:
Use the DARKEN key for documents with faint characters.
If you are in doubt as to the suitability of the settings:
1. Press the START/COPY key to make a copy.
2. Check the copy quality and change the settings if necessary.
1
Itmxml”
14