Filter
Top Products
Rimage Everest Printer
24 110632_L
Cleaning the Everest printer
Clean the print head
Before you begin:
Power off the printer.
1. Access the print head.
a. Press the two cover latches to release the side cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier. For specific instructions, refer to page
20.
2. Clean the print head.
p Caution! Wipe the print head from
one end to the other. Do not stop
wiping in the middle of the print
head.
p Caution! Do not scratch the print
head. The white area in the picture
shows the area to clean.
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to wipe across the print head from one end to the other.
c. Repeat as needed until the print head is clean of dust and debris.
d. Use the sponge swab to remove any waxy buildup from the roller below the print head.
Latch 1
Printhead
Wipe
direction
3. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
d. Power on the printer. The printer is ready.