Filter
Top Products
4
User Manual
SATA-150 1-Int/1-Ext Port PCI Adapter RC205
Manager tab.
3. Double click Other Devices then PCI RAID Controller.
4. Click Driver tab, then Update Driver.
5. Insert the Driver diskette, check Specify the location of the driver (advanced) and click Next.
6. Select Search for the better driver option, check Specify a location, uncheck Removable
Media, type in A:\, and click Next.
7. Click Next and then Finish.
8. Remove the Driver diskette and click Yes to restart Windows to complete driver installation.
For Existing Windows ME Systems
1. After the Serial ATA PCI Host Adapter and attached drives are configured, boot up Windows.
2. At the Add New Hardware Wizard, check Specify the location of the driver (advanced), and
click Next.
3. Insert the Driver diskette, check Specify a location, uncheck the other boxes, type in A:\, and
click Next.
4. Click Next and then Finish.
5. Remove the Driver diskette and restart Windows to complete driver installation.
Verification of the Proper Installation for Windows 98/98SE/ME
1. Double click My Computer/Control Panel/System. Click Device Manager tab.
2. Double click SCSI Controllers, Silicon Image Sil-3112 Serial ATA Controller should be listed.
3. Highlight Silicon Image Sil-3112 Serial ATA Controller and click Properties. A message This
device is working properly is displayed in the dialog box, the driver has been correctly installed.
If any error message is displayed, remove Silicon Image Sil-3112 Serial ATA Controller and restart
your system.
2.3. Windows NT 4.0 Driver Installation
For New Windows NT 4.0 System
1. After the Serial ATA PCI Host Adapter and attached drives are configured, follow Microsoft
procedures to install Windows accordingly.
2. At the Windows Set-up screen, press F6 to specify and add the driver.
3. Press S, select Other, then press Enter.
4. Insert the Driver diskette and press Enter.
5. Select Silicon Image Sil-3112 Serial ATA Controller Driver and press Enter.
6. Press Enter to continue and follow on-screen instructions to complete Windows NT 4.0
installation.
For Existing Windows NT 4.0 (in old ATA channel) System
1. After the Serial ATA PCI Host Adapter and attached drives are configured, boot up Windows.