Filter
Top Products
SATA+ULTRA ATA RAID CONTROLLERRC212 User Manual
20
＊For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to Windows.
2. At the Found New Hardware Wizard window pop-up, please click Cancel button
to cancel the driver installation for the device at this moment. The driver for this
device will be installed in the next step.
3. Please insert the CD driver bound with PCI SATA+PATA RAID card into your
CD-ROM Drive.
4. At the Windows desktop, click Start, then Run.
5. Type D:\RC-212\Setup.exe, click OK. (Change D:\ to match your CD-ROM drive
letter)
6. Follow the on-screen instructions to complete the installation.
7. Restart Windows to complete the installation.
For Windows® 2000
＊
For A New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy
disk, copy the contents of the “RC-212\DriverDisk” folder, found on the driver CD,
onto a blank floppy disk then follow the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Windows® 2000 installation procedure.
3. Restart the computer when prompted by the installation.
4. At the Windows® 2000 Setup screen, press F6 to install the RAID driver.
5. When prompted, press S to specify the location of the driver.
6. Insert the floppy disk, then press Enter.