Filter
Top Products
System Reset
23
In the event that your PFP Controller appears to have a software problem, or adjustments have been made
so far out of range that the image is no longer on-screen or discernable, you can reset the processor back to
factory values. This sets ALL settings back to factory values, so any adjustments made previously will be lost.
T
o reset your PFP Controller, follow this procedure:
· Turn off the MAIN POWER switch on the back of the processor
· Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back on.
Continue holding the down arrow button until the LED on the front panel blinks,
then release the down arrow button.
Once this is done, your processor has been completely reset to factory values.
After resetting the unit, Composite video will be the active source.
SYSTEM RESET is not on any of the menus; it must be performed using the instructions above.
IMAGE SHIFT moves the entire image up, down, left or right. If the image is slightly off-center on-screen after
installation, using IMAGE SHIFT can center the image on your screen or display.
While using IMAGE SHIFT will not cause any problems with your display, it is possible to use too much image
shift, which could cause the image to shake or disappear. Therefore, Runco recommends that image shift be
done with the display device itself whenever possible.
Input Image Shift shifts the part of the image that is being “input” to the Controller. Output Image Shift shifts the
image being output to the display.
Image Shift
Hstart: 0
Vstart: 0
Image Shift