Filter
Top Products
8_SADT-103WM
9. See the wiring diagram below for connecting the cables of the Camera Adaptor.
A. Remove one of the Connectors connected to the cable end of the Camera Adaptor.
B. Peel off the coating on the cable end of the Connector and connect it to the external
cable using soldering.
(See the cable wiring diagram in the installation guide of the Camera for connecting the
cables.)
C. Use an insulation tape to wrap up the soldering portion of two cables.
D. Connect the Connector to the Camera Adaptor again.
E. Repeat the above 4 steps to connect all of the 4 Connectors to the corresponding
external cables.
F. In the last step, connect the BNC jack.
CAMERA ADAPTOR CAMERA ADAPTOR
CABLE
CONNECTOR
BNC JACK
CONNECTOR
Soldering
External Cable
SADT-103WM_ENG.indd 8 2008-03-18 오전 9:13:59