Filter
Top Products
Connecting the USB cable
1
Connect a USB cable to the USB port on the computer.
2
Connect the opposite end of the USB cable to the
USB cable port on the right side of the yepp.
● If you disconnect the USB cable from your PC while
implementing a command or initializing during
USB driver installation, your PC may not function correctly.
3
The USB driver is installed with a message saying that it
is searching for a new device. You may not see the
display screen during installation.
Go to the device manager to check that
installation has been successfully completed.
4
Upon installation of the USB driver
"SAMSUNG YP-60”
will appear in the
[Start] → [Settings] → [Control Panel] →
[System Properties] → [Device Manager].
➤ Before connecting the yepp to PC, make sure to install yepp Studio.
Location of Controls
Turning Power On and Off
Playing Music Pausing Music
21
YP-60 Quick Guide
ENC/NAVI.
Button
Move to Track/
Speed Search Button
Volume Button
MENU/
Loop Repeating Button
Sports Function Button
Play/Stop/Pause
On/Off Button
Display
Hold Switch
Reset Hole
USB Cable
Connection Port
ENC Jack
Earphone JackHeart Rate Measurement Sensor
● Power On : Press and hold the button to turn on the power.
● Power Off : Press and hold the button to turn off the power.
Press the button.
● Playback starts.
Press the button to pause playback.
● While in Pause mode, briefly press again to resume playback.
● If the device won’t respond even after pressing the buttons,
reboot it by pressing the Reset Hole with a pin.
USB connect cable