Sanyo PLC-XT10 Projector User Manual


 
43
APPENDIX
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If the problem still persists
after following all operating instructions,
contact the sales dealer where you purchased the
projector or the service center.
Give the model number and explain the difficulty. We will advise you how to obtain service.
Remote Control Unit
does not work.
Check the batteries.
Check ALL-OFF switch on Remote Control Unit is set to ON..
Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
Make sure you are not too far from a projector when using Remote Control Unit.
Maximum operating range is 16.4 (5m).
Make sure the code of Remote Control Unit is set to conform to projector.
(See SETTING section on page 36, 37.)
Problem: Try these Solution
Wireless Mouse
function does not
work.
Check cable connection between a projector and your computer.
Check the mouse setting on your computer.
Turn a projector on before turning on a computer.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
The CE Mark is a Directive conformity mark of the European Community (EC).