Filter
Top Products
Page 2-8
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
2.3 LCD Panel Configuration
The LCD Panel on the CL608e/CL612e is used in conjunction with the LINE and FEED
switches by the operator to manually enter printer configuration settings. Many of the
settings can also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting. If you
load a label job that includes software settings and then enter a new setting via the LCD
Panel, the manually set values will be used by the printer. If you set the values manually
and then download a job with software settings, the software settings will be used.
There are 7 configuration and operation modesyou can aaccess from the LCD panel. To
enter the desired mode, the KEY SEQUENCE combination listed in the table below must be
performed. The initial LCD display message is shown for each mode.
EDOMECNEUQESYEKYALPSIDLAITINIEGAP
edoMlamroNrewoP
ENILNO
000000:YTQ
9-2
edoMdecnavdAREWOP+ENILEDOMDECNAVDA31-2
edoMtnirPtseTREWOP+DEEF
EDOMTNIRPTSET
NOITARUGIFNOC
33-2
edoMgnitteStluafeD
)locotorPdtS(
REWOP+DEEF+ENIL
GNITTESTLUAFED
ONSEY
43-2
edoMecnanetniaM
+ENIL+NO4-2WSD
REWOP+DEEF
EDOMECNANETNIAM
FFO>-NO4-2WSPID
53-2
edoMpmuDxeHREWOP+NO4-2WSD
ENILNO
000000:YTQ
83-2
erawmriF
edoMdaolnwoD
REWOP+NO6-2WSD
DAOLNWODHSALF
YDAER
93-2