Filter
Top Products
Verify that you have the following materials when unpacking:
• Printer
• Power Cord
• Extra Ribbon Core
• Operator’s and Technical Reference Manual
SETTING UP THE PRINTER
Consider the following when setting up the printer:
• Locate a solid flat surface with adequate room to set the printer. Make sure
there is enough room at the top and right-hand (facing the printer) side to
provide clearance for the label access door to swing open.
• The location should be near the host computer or terminal. The maximum
distance for RS232 cables is 50 feet and six feet for Centronics Parallel
cables. Cables can be purchased locally, and their configuration will depend
upon the host system being used.
• For information on interfacing the printer to a host system, see
Section 5: Interface Specifications.
CL Printer
Power Cable
Operator Manual
Extra Ribbon Core
Section 2. Installation and Configuration
SATOCL Series Printers9001035 Rev. EPage 2-3