Filter
Top Products
Hex Dump Selection (DSW2-4). Selects Hex Dump mode (see page 2-20).
Receive Buffer Selection(DSW2-5). Selects the operating mode of the receive
buffer. See Section 5: Interface Specifications for more information.
Protocol Code Selection (DSW2-7). Selects the command codes used for
protocol control. Refer to page 4-2 for more information.
M84XX Emulation Mode (DSW2-8). For emulating special M84XX series
software. Should be used only if problems are encountered when using existing
M84XX software.
Mode Selection (DSW3-1 and DSW3-2). Selects the operating mode of the
printer. Batch/Continuous disables the label sensors.
Label Sensor Selection (DSW3-3). Enables or disables the Label Sensor. If the
Sensor is enabled, it will detect the edge of the label and position it automatically. If
it is disabled, the positioning must be under software control using Line Feed
commands.
DSW2-4 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
DSW2-5 SETTING
Off Single Job
On Multi Job
12345678
ON
OFF
DSW2
DSW2-7 SETTING
Off Standard
On Non-Std
12345678
ON
OFF
DSW2
DSW2-8 SETTING
Off Off
On Suppress
12345678
ON
OFF
DSW2
DSW3-1 DSW3-2 SETTING
Off Off Batch/Continuous
Off On Tear Off
On Off Cutter
On On Dispenser
12345678
ON
OFF
DSW3
DSW3-3 SETTING
Off Sensor Used
On Not Used
12345678
ON
OFF
DSW3
Section 2. Installation and Configuration
Page 2-229001035 Rev. ESATOCL SeriesPrinters