Filter
Top Products
SECTION 2: INSTALLATION
Page 2-20 GT Series Operator’s Manual
6. Pull up the Label Damper by the
purple knob in a counterclockwise
direction until it locks into place
vertically. If it is already in a vertical
position proceed to the next step.
7. Pass the paper under the label
guide and paper sensor. Pull the
label damper knob, and the label
damper will drop down to press
against the paper.
• When replacing paper, bear in mind that the
print head and its surrounding area remain hot.
Keep your fingers away from these areas to
prevent injury.
• Avoid touching even the edge of the print head
with your bare hands.
8. Loosen the label guide knob, and
adjust the slide guide so that it
lightly touches the edge of the
paper. Now fasten the label guide
knob tightly.
9. Remount the print head by pushing down on the head lock
lever. The print head should lock into place firmly.
10. If desired, close the main cover and do a test print to
check that the label roll has been loaded properly. Be
careful not to get your fingers caught at the bottom ledge
when you are closing the main cover.
• When replacing paper, bear in mind that the print head and its surrounding
area remain hot. Keep your fingers away from these areas to prevent injury.
Label Guide Knob
Label Damper
Label Guide
Label Damper
Label Guide Knob
P
rint
H
ead
Head lock
lever