Filter
Top Products
APPENDIX A.
OPTIONAL ACCESSORIES
INTRODUCTION
This section contains instructions for using the following CL Series “e”optional
features:
•
Label Rewinder
•
Label Cutter
•
Label Dispenser
•
PCMCIA Memory Expansion
•
Internal Flash ROM Memory Expansion
•
Calendar
• Interface Cards
LABEL REWINDER ALL MODELS
The rewinder is an external unit that allows for labels and tags to be rewound in rolls
up to 8.5 inches in diameter. It derives its power directly from the printer’s EXT
connector using a built-in cable. The rewinder provides the ability to rewind
tags/labels from the printer and subsequently be unwound for later use with
applicators.
Installation
1. Position the Rewinder at the front of the printer and align it with the label slot.
(The Rewind Wheel/Spindle should be positioned away from the printer.)
2. Connect the built-in cable from the Rewinder to the EXT connector at the rear of
the printer.
3. On the Rewinder, remove the metal clamp from the Rewind Spindle.
4. Feed the lead end of the label stock under the first spindle and onto the Rewind
Spindle. Feed the stock around the spindle once, then replace the metal clamp
over the label stock. Wind another revolution to ensure the labels are secure on
the spindle.
5. Select the REWIND option on the rewinder, then set the power switch to ON.
(The printer must be powered ON for the rewinder to function.)
Removing and Unwinding the Roll
As labels are printed, tension from the rewinder should keep the label stock taut as it
wraps itself on the spindle.
SATO CL Series “e” Printers PN 9001074 Rev. B Page A-1