Filter
Top Products
CONSTELLATION ES SERIAL ATA PRODUCT MANUAL, REV. F 25
3.4 DRIVE MOUNTING
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See
Figure 6 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 in (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
Weight: (maximum)
2TB models 1TB models 500GB models
710g (1.565 lb) 640g (1.411 lb) 610g (1.345 lb)
Note. These dimensions conform to the Small Form Factor Standard documented in SFF-8301 and
SFF-8323 found at www.sffcommittee.org
Breather
Hole
mm
in
mm
in
mm
in
Figure 6. Mounting dimensions—top, side and end view