Filter
Top Products
8 Hawk 2XL Family Installation Guide, Rev. C
_______________________________________________________________________________________________________________________
Safety instructions
1. The disc drive is to be installed in a customer supplied
enclosure where the surrounding air does not exceed
50
o
C.
2. Four (4) 6-32 UNC-2A screws are required for installation.
Maximum screw length into side of drive is 0.15 inches (9/
64 inch) (3.81 mm). Maximum screw length into bottom is
0.20 in. (3/16 inch) (5.08 mm). Screw tightening torque is
6.0 lb-in (.675 NM) max with minimum thread engagement
of 0.12 in (1/8 inch) (3.00 mm).
3. The power requirements are shown in the Product Informa-
tion section.
4. The power supply must satisfy the safety requirements for
SELV (Safety Extra Low Voltage) circuits.
5. Service is to be provided by trained Seagate service
personnel.
6. The incorporation of the disc drives listed in this guide into
a customer enclosure must meet the appropriate safety
requirements of the country in which it is used (e.g. UL
1950, CAN/CSA-C22.2 No. 950-M89, DIN VDE 0805:1993
and EN60950: 1992 (IEC 950).
Note
Power must be off when connecting or disconnecting.