Filter
Top Products
Hawk 2XL Family Installation Guide, Rev. C 13
_______________________________________________________________________________________________________________________
("X" means the function selection can be made with jumpers on
that connector;
"Y" means the signal is available to host through that connec-
tor).
Notes[ ] for Table 1:
[1] Use either J6 or J1-Aux, but not both.
[2] I/O connector J1 plugs directly into host. No jumper can be
installed on J1. The host supplies the logic state of these
function signals; causing the selection of these functions.
[3] The host can drive a remotely located Drive Activity LED
using this signal.
[4] Use either J1 or J6, but not both.
[5] Jumper plugs can be used on J1-Auxiliary pins 1-2, 3-4, 5-
6 and 7-8 to set drive ID if desired, but usually a connector/
cable is plugged to J1-Auxiliary to run these signals to the
host for remote ID selection.
[6] The host selects drive ID through J1.