Filter
Top Products
Hawk 2XL Family Installation Guide, Rev. C 23
_______________________________________________________________________________________________________________________
2. Does your system have 5.25-inch drive bays? Your Seagate
drive is designed to fit into a 3.5-inch wide drive bay. If
your computer has 5.25-inch drive bays, then you must
mount the drive ("N" or "W" models only) in a conversion
frame kit before then you must mount the drive ("N" or "W"
models only) in a conversion frame kit before it will fit into
your computer. Purchase a conversion frame kit from your
computer dealer if necessary.
3. Connect the 50 or 68 pin interface cable to the hard drive
interface connector on the SCSI host adapter card. Be
careful not to bend the pins on the host adapter card con-
nector. Refer to your SCSI host adapter manual for the
location of the interface connector.
The sockets on the interface cable must be matched cor-
rectly with the pins on your SCSI host adapter interface
connector. Verify the location of pin 1 on the SCSI host
adapter using your computer system's manual. Pin 1 on
the interface cable is indicated by the stripe along the edge
of the cable. Plug the cable into the hard drive interface
connector on your SCSI host adapter.
4. Thread the other end of the interface cable through your
drive bay and connect to the disc drive, as shown in Fig-
ure 4a, 4b, 4c or 4d.
The sockets on the interface cable must be matched cor-
rectly with the pins on the disc drive. Pin 1 on the interface
cable is indicated by the strip
along the edge of the cable;