Filter
Top Products
Hawk 2XL Family Installation Guide, Rev. C 25
_______________________________________________________________________________________________________________________
• Using a conversion frame kit:
To mount a 3.5" drive in a 5.25" drive bay, install the
drive in the frame kit (installation instructions and re-
quired hardware are included with a frame kit). Then
mount the frame kit in the drive bay.
If you are installing two disc drives, repeat the appropri-
ate procedure above for the second drive.
• Using a special module:
"WC" drives should be fitted with slides or most likely,
mounted in a special module that slides into the host
equipment.
• Drive activity LED:
If the drive mounts such that the drive activity LED does
not show when the computer cover is on, the computer
may provide for a remote LED two conductor cable to
be used on all models. This cable plugs into J6 on the
front of the drive as shown in Figure 3a.
"WC" model drives have a line available in the J1-80 pin
interface. Check system documentation to see if J1 sig-
nal is used or if a cable should be attached to J6.