Filter
Top Products
36 Hawk 2XL Family Installation Guide, Rev. C
_______________________________________________________________________________________________________________________
Note:
Seagate Technology assumes no liability for lost user data.
From the C/> prompt, try to switch to each logical drive (C:, D:,
E:, etc.) to see if you can get a prompt for each logical drive
(C\>, D\>, E\>, etc.). With each prompt that you select, type
CHKDSK. This shows if the logical drives are usable for storing
data and programs. If the logical drives you set up are not rec-
ognized, try the FDISK set up routine and FORMAT again. You
may have made a small mistake at some point in the installa-
tion procedure.
Make sure that the total capacity shown for your new drive is
equal (or close to) the formatted capacity given in the Product
Information table, column B at the end of this guide. If not, you
may need to get a newer SCSI adapter card that allows you to
access the complete drive.
If the complete DOS operating system software is not on your
primary DOS drive (usually C), read it in from diskettes on drive
A.