Sharp AR-M276 All in One Printer User Manual


 
57
5
DISPLAY MESSAGES
If one of the following messages appears in the display, take prompt action as instructed by the message.
Message Cause and solution Page
ENTER YOUR ACCOUNT
NUMBER.
Auditing mode is enabled. Enter your account number.
55
A MISFEED HAS OCCURRED. Remove the misfeed as explained in "MISFEED REMOVAL". 63
2-SIDED COPIES CANNOT BE
MADE ON THIS PAPER TYPE.
This appears when you attempt to make two-sided copies on
special paper that cannot be used for two-sided copying. Cancel
two-sided copying or change the paper.
15, 27
REMOVE PAPER FROM THE
<*>TRAY.
The indicated output tray is full. Remove the output from the tray.
(<*> indicates the tray that is full.)
-
CLOSE THE <**> COVER. The indicated cover is open. Close the cover. (<**> indicates the
cover that is open.)
-
PLEASE EXTEND BYPASS-TRAY.
When copying from the bypass tray, be sure to pull out the bypass
tray extension.
18
COVER SHEETS MUST BE THE
SAME SIZE AS THE COPY
PAPER USED.
When adding a cover, load paper in the bypass tray that is the
same size as the paper in the tray selected for copying. 48
TONER SUPPLY IS LOW. The toner cartridge must be replaced soon. 71
CHANGE THE TONER CARTRIDGE.
The toner cartridge is out of toner. Replace the toner cartridge. 71
CHECK THE TONER CARTRIDGE.
Make sure that the toner cartridge is installed correctly. 71
THE DOCUMENT FEEDER IS
DISABLED.
The RSPF has been disabled in the key operator programs. Use
the document glass.
22
SELECTED PAPER TRAY IS
PROHIBITED. PLEASE SELECT
ANOTHER PAPER TRAY.
This appears when a tray is selected that has been prohibited in
"TRAY SETTINGS" in the custom settings. 52
PLEASE CHECK THE PAPER
SIZE OF TRAY <***>.
The tray's paper size setting is different from the actual paper size.
Load the correct size of paper. The tray is indicated in <***>.
17
ADD STAPLES. The finisher is out of staples. Replace the staple cartridge as
explained in "STAPLE CARTRIDGE REPLACEMENT".
72
PLEASE REMOVE PAPER FROM
THE STAPLER COMPILER.
Paper remains in the stapler compiler. Remove the paper.
69
MEMORY IS FULL. PRESS
[START] TO BEGIN COPYING OR
[CA] TO CANCEL.
The memory becomes full while scanning originals. Press the
[START] key ( ) to copy only the originals that have been
scanned, or press the [CLEAR ALL] key ( ) to cancel the job.
-