Filter
Top Products
23
1. Select a paper tray on the touch panel.
●
Up to 4 PAPER TRAY keys appear depending on the number
of the paper tray installed (except an optional large capacity
tray).
2. Select a paper size for “EXTRA” setting.
To select a size of AB series, press the “AB” key and press a desired
paper size.
●
Select the paper size which matches the paper to be loaded into
the paper tray.
●
This setting can also be used for paper trays in an optional 500-
sheet paper drawer (AR-CS2N).
3. To set a desired paper size for the “EXTRA” paper, press
the “SIZE INPUT” key and input the paper size.
●
Adjust X (horizontal) and Y (vertical) dimensions using the
and keys.
●
The value can be set in 1/8" increments from 5-1/2" to 17" for X
and from 7-1/4" to 11-3/4" for Y.
4. Press the “OK” key.
Require Key Operator Code
This program is used to prevent the copier from being started by
people other than key operator. If this program is set, the message
“ENTER KEY OPERATOR CODE. -----” will appear each time the
power switch is turned to the “ON” position.
To require key operator code entry for access to the copier,
press the check box of “REQUIRE KEY OPERATOR CODE”
to display a check mark in the check box.
To enable access to the copier without key operator code
entry, press the check box of this program again to clear the
check mark in the check box.
KEY OPERATOR PROGRAMS
SIZE SETTING FOR [EXTRA]
PAPER TRAY
OK
11 17 8/ 14
2
1
2
1
2
1
2
1
4
1
2
1
2
1
2
1
8/ 13 8/ 11
1 234
8/ 11R 5/ 8/ 7/ 10/R EXTRA
AB SIZE INPUT
INCH
KEY OPERATOR PROGRAMS
SIZE SETTING FOR [EXTRA]
INCH
PAPER TRAY
OK
1 234
AB
7
(5 1/2~17)
inch
(7 1/4~11 3/4)
inch
Y
X
/
5
2
1
/
4
1
SIZE INPUT
KEY OPERATOR PROGRAMS