Filter
Top Products
Sharp AR-C265P User’s Guide
107
Network Menu
Note: Factory default settings are shown in bold.
Item Settings Explanation
TCP/IP ENABLE
DISABLE
Enables or disables this network
protocol.
NETBEUI ENABLE
DISABLE
Enables or disables this network
protocol.
IP ADDRESS
SET
AUTO
MANUAL
Change this to Manual to specify the IP
address through the front panel (see
next entry). Required for non-DHCP
networks.
IP ADDRESS xxx.xxx.xxx.xxx
Default =
198.168.100.100
Current assigned IP address. To
change:
•Press ENTER.
•Use
+/– keys to increment first
octet.
• Press ENTER to move on to the next
octet.
•Use
+/– keys to increment second
octet.
• Press ENTER to move on to the next
octet.
•Use
+/– keys to increment third
octet.
• Press ENTER to move on to the last
octet.
•Use
+/– keys to increment 1st
octet.
•Press ENTER to register the new
address.
SUBNET MASK xxx.xxx.xxx.xxx
Default =
255.255.255.000
Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.254
Current assigned gateway address. To
change, proceed as above.
Factory Default [EXECUTE] Initializes the network card.
WEB/IPP ENABLE
DISABLE
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.