Sharp DM-3551 Printer User Manual


 
21
Erase
The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in its initial setting.
Edge erase
Eliminates shadow lines around the edges of copies
caused when thick paper or a book is used as an original.
Center erase
Eliminates shadow lines produced by the bindings of
bound documents.
Edge + center erase
Eliminates shadow lines around the edges of copies and
eliminates the shadow at the center of copies.
1
Touch the [ERASE] key on the SPECIAL MODES
screen.
JOB BUILD
ERASE
The erase setting screen
will appear.
2
Select the desired erase mode.
ERASE
EDGE
ERASE
CENTER
ERASE
EDGE+CENTER
ERASE
Select one of the three
erase modes. The selected
key will be highlighted.
3
Adjust the amount of erase and touch the [OK]
key.
inch
1/2
(0 1)
EDGE
CANCEL OK
Use the and keys to
adjust the erase width and
then touch the [OK] key.
Original
Copy
4
Touch the [OK] key on the special modes screen.
After adjusting the exposure, follow any of the
copying procedures.
SPECIAL FUNCTIONS
To cancel the erase function, touch the [CANCEL] key on
the erase setting screen.
copy-2_Ep.P65 2/04/01, 19:1721