Filter
Top Products
5-26
SADDLE STITCH FINISHER
Troubleshooting (concerning the saddle stitch finisher)
Check the list below before calling for service.
Problem
Stapling position
is not correct
(including saddle
stitch).
The saddle stitch
finisher does not
operate.
Stapling cannot
be performed
(including saddle
stitch).
Stapled sets are
not stacked
correctly or some
sheets in a set
are not stapled.
Cannot be
punched.*
Check
Solution or cause
Check the stapling position setting. (See pages
5-27 and 5-28.)
Close all covers. (See page 5-17.)
Remove all remaining paper from the stapler
compiler referring to step 4 on page 5-22.
Remove jammed staples. (See page 5-22.)
Replace the staple cartridge. (See page 5-21.)
Check that a staple cartridge has been installed.
(See page 5-22.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Dispose of punch scraps. (See page 5-23.)
Stapling position not set properly?
Are any saddle stitch finisher covers
open?
Message indicating need to remove
paper from the stapler compiler
displayed?
Message requesting check for the staple
unit displayed?
Message requesting adding staples
displayed?
Different size paper included?
Paper heavily curled?
Message requesting check for punch
module displayed?
* When a hole punch module is installed