Sharp DX-B450P Printer User Manual


 
7-1
Chapter 7: Networking
The DX-B350P/B450P is a fast network capable printer
and supports an Ethernet 10/100 Base-Tx network
connection.
Protocols
The following protocols are supported:
Initial Setting of the Printer’s IP Address
All devices on the network must have an IP address. The
printer comes configured from the factory to obtain an
address automatically from your network’s DHCP server.
If your network does not support DHCP or you want to set
the printer to a specific IP address, you must set it
manually.
Setting the IP Address through DHCP
Many networks have a Dynamic Host Configuration
Protocol (DHCP) server. A DHCP server automatically
programs an IP address into every terminal and printer on
the network that is configured to use DHCP. A DHCP
server is built into most cable and DSL routers. If you use a
cable or DSL router, see your the device documentation for
information on IP addressing.
TCP/IPv4, UDP, BOOTP, DHCP, ARP, ICMP, DDNS, WINS, LPR
HTTP for Embedded Web Server
IPv6, ICMPv6, Address Auto Configuration and Neighbor Discovery
for IPv6
Host Resources MIB (RFC 1514), MIB II (RFC 1213), Printer
MIBv2 (3805), SNMPv1/v2
Email SMTP client for alerts, POP3 for receiving print data
Apple EtherTalk, Bonjour
Netware V5.5, V6.5
IPX (SPX/NCP)
LPD
In this Chapter...
Protocols
Initial Setting of the
Printer’s IP
Address
Configuring the
Driver
Printer Network
Configuration
Notifications
IP Filtering
•IPv6
Implementation
•SNMP